Yn ystod y cyfnod gweithio, mae angen i'r defnyddiwr wirio rhan gêr y rholer yn system fwydo'r slitter yn aml, cadarnhau bod yr iriad yn dda, ac ychwanegu ac ailosod yr olew gêr mewn pryd. Ar yr un pryd, rhowch sylw i wirio a oes baw rhwng y rholeri a rhwng y gerau. Os oes baw, dylid ei symud ar unwaith i sicrhau gweithrediad arferol.
& nbsp;
Nid yn unig, yn ystod y defnydd o'r slitter, mae angen i'r staff wirio ymlaen llaw a chadarnhau bod y sgriwiau a'r cnau sydd wedi'u cyfuno rhwng y gwahanol fecanweithiau yn cael eu tynhau'n dda heb looseness. Yn ogystal, rhowch sylw i wirio a oes paralelrwydd da i'r rholer bwydo.
& nbsp;
Yn ogystal â'r uchod, mae angen i'r staff wirio'n aml a oes unrhyw ffenomen annormal fel difrod ac anffurfiad ym mhob rhan o'r slitter, ac a yw'r switsh a'r sgrin arddangos ar y panel llawdriniaeth yn annormal. Os canfyddir unrhyw annormaledd, rhaid ei drin mewn pryd.
& nbsp;
In order to ensure that the slitter feeding system can operate normally, the staff need to carry out the following inspections regularly (generally after every six months of operation or 1000 hours of use):
& nbsp;
1. Check whether the external wiring of stripper feeding system is in good condition. If any deformation or damage is found, repair it in time;
& nbsp;
2. Regularly check whether the buttons on the operation panel of the slitter feeding system are sensitive and reliable. If there is any oil stain, it shall be removed in time.
& nbsp;
3. Regularly check the overall operation status of the slitter feeding system and whether the ambient temperature is normal.

